From c262465294d0b15f158518501d3918c52f7c1b22 Mon Sep 17 00:00:00 2001 From: Naushir Patuck Date: Fri, 5 Mar 2021 15:40:45 +0000 Subject: [PATCH 0279/1085] media: bcm2835-unicam: Fix bug in buffer swapping logic If multiple sets of interrupts occur simultaneously, it may be unsafe to swap buffers, as the hardware may already be re-using the current buffers. In such cases, avoid swapping buffers, and wait for the next opportunity at the Frame End interrupt to signal completion. Additionally, check the packet compare status when watching for frame end for buffers swaps, as this could also signify a frame end event. Signed-off-by: Naushir Patuck --- .../media/platform/bcm2835/bcm2835-unicam.c | 21 ++++++++++++++++--- 1 file changed, 18 insertions(+), 3 deletions(-) --- a/drivers/media/platform/bcm2835/bcm2835-unicam.c +++ b/drivers/media/platform/bcm2835/bcm2835-unicam.c @@ -800,6 +800,7 @@ static irqreturn_t unicam_isr(int irq, v unsigned int sequence = unicam->sequence; unsigned int i; u32 ista, sta; + bool fe; u64 ts; sta = reg_read(unicam, UNICAM_STA); @@ -817,12 +818,18 @@ static irqreturn_t unicam_isr(int irq, v return IRQ_HANDLED; /* + * Look for either the Frame End interrupt or the Packet Capture status + * to signal a frame end. + */ + fe = (ista & UNICAM_FEI || sta & UNICAM_PI0); + + /* * We must run the frame end handler first. If we have a valid next_frm * and we get a simultaneout FE + FS interrupt, running the FS handler * first would null out the next_frm ptr and we would have lost the * buffer forever. */ - if (ista & UNICAM_FEI || sta & UNICAM_PI0) { + if (fe) { /* * Ensure we have swapped buffers already as we can't * stop the peripheral. If no buffer is available, use a @@ -833,7 +840,15 @@ static irqreturn_t unicam_isr(int irq, v if (!unicam->node[i].streaming) continue; - if (unicam->node[i].cur_frm) + /* + * If cur_frm == next_frm, it means we have not had + * a chance to swap buffers, likely due to having + * multiple interrupts occurring simultaneously (like FE + * + FS + LS). In this case, we cannot signal the buffer + * as complete, as the HW will reuse that buffer. + */ + if (unicam->node[i].cur_frm && + unicam->node[i].cur_frm != unicam->node[i].next_frm) unicam_process_buffer_complete(&unicam->node[i], sequence); unicam->node[i].cur_frm = unicam->node[i].next_frm; @@ -870,7 +885,7 @@ static irqreturn_t unicam_isr(int irq, v * where the HW does not actually swap it if the new frame has * already started. */ - if (ista & (UNICAM_FSI | UNICAM_LCI) && !(ista & UNICAM_FEI)) { + if (ista & (UNICAM_FSI | UNICAM_LCI) && !fe) { for (i = 0; i < ARRAY_SIZE(unicam->node); i++) { if (!unicam->node[i].streaming) continue;