From fc2b74700d1b337164e89a12235813d41fa1e832 Mon Sep 17 00:00:00 2001 From: James Hughes Date: Thu, 31 Oct 2019 14:39:44 +0000 Subject: [PATCH 0186/1085] net:phy:2711 Allow ethernet LED mode to be set via device tree Add device tree entries and code to allow the specification of the lighting modes for the LED's on the ethernet connector. Signed-off-by: James Hughes net:phy:2711 Change the default ethernet LED actions This should return default behaviour back to that of previous releases. --- drivers/net/phy/broadcom.c | 11 +++++++---- 1 file changed, 7 insertions(+), 4 deletions(-) --- a/drivers/net/phy/broadcom.c +++ b/drivers/net/phy/broadcom.c @@ -350,6 +350,9 @@ static void bcm54xx_ptp_config_init(stru static int bcm54xx_config_init(struct phy_device *phydev) { int reg, err, val; + u32 led_modes[] = {BCM_LED_MULTICOLOR_LINK_ACT, + BCM_LED_MULTICOLOR_LINK}; + struct device_node *np = phydev->mdio.dev.of_node; reg = phy_read(phydev, MII_BCM54XX_ECR); if (reg < 0) @@ -405,10 +408,10 @@ static int bcm54xx_config_init(struct ph bcm54xx_phydsp_config(phydev); + of_property_read_u32_array(np, "led-modes", led_modes, 2); + /* For non-SFP setups, encode link speed into LED1 and LED3 pair * (green/amber). - * Also flash these two LEDs on activity. This means configuring - * them for MULTICOLOR and encoding link/activity into them. * Don't do this for devices on an SFP module, since some of these * use the LED outputs to control the SFP LOS signal, and changing * these settings will cause LOS to malfunction. @@ -419,8 +422,8 @@ static int bcm54xx_config_init(struct ph bcm_phy_write_shadow(phydev, BCM54XX_SHD_LEDS1, val); val = BCM_LED_MULTICOLOR_IN_PHASE | - BCM54XX_SHD_LEDS1_LED1(BCM_LED_MULTICOLOR_LINK_ACT) | - BCM54XX_SHD_LEDS1_LED3(BCM_LED_MULTICOLOR_LINK_ACT); + BCM54XX_SHD_LEDS1_LED1(led_modes[0]) | + BCM54XX_SHD_LEDS1_LED3(led_modes[1]); bcm_phy_write_exp(phydev, BCM_EXP_MULTICOLOR, val); }