From abb45a2477f533cd4aab3085defdff131e2e8c4f Mon Sep 17 00:00:00 2001 From: Christian Marangi Date: Mon, 6 May 2024 14:32:46 +0200 Subject: [PATCH] net: stmmac: dwmac-ipq806x: account for rgmii-txid/rxid/id phy-mode Currently the ipq806x dwmac driver is almost always used attached to the CPU port of a switch and phy-mode was always set to "rgmii" or "sgmii". Some device came up with a special configuration where the PHY is directly attached to the GMAC port and in those case phy-mode needs to be set to "rgmii-id" to make the PHY correctly work and receive packets. Since the driver supports only "rgmii" and "sgmii" mode, when "rgmii-id" (or variants) mode is set, the mode is rejected and probe fails. Add support also for these phy-modes to correctly setup PHYs that requires delay applied to tx/rx. Signed-off-by: Christian Marangi Reviewed-by: Andrew Lunn Signed-off-by: David S. Miller --- drivers/net/ethernet/stmicro/stmmac/dwmac-ipq806x.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-ipq806x.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-ipq806x.c @@ -171,6 +171,9 @@ static int ipq806x_gmac_set_speed(struct switch (gmac->phy_mode) { case PHY_INTERFACE_MODE_RGMII: + case PHY_INTERFACE_MODE_RGMII_ID: + case PHY_INTERFACE_MODE_RGMII_RXID: + case PHY_INTERFACE_MODE_RGMII_TXID: div = get_clk_div_rgmii(gmac, speed); clk_bits = NSS_COMMON_CLK_GATE_RGMII_RX_EN(gmac->id) | NSS_COMMON_CLK_GATE_RGMII_TX_EN(gmac->id); @@ -412,6 +415,9 @@ static int ipq806x_gmac_probe(struct pla val |= NSS_COMMON_GMAC_CTL_CSYS_REQ; switch (gmac->phy_mode) { case PHY_INTERFACE_MODE_RGMII: + case PHY_INTERFACE_MODE_RGMII_ID: + case PHY_INTERFACE_MODE_RGMII_RXID: + case PHY_INTERFACE_MODE_RGMII_TXID: val |= NSS_COMMON_GMAC_CTL_PHY_IFACE_SEL; break; case PHY_INTERFACE_MODE_SGMII: @@ -427,6 +433,9 @@ static int ipq806x_gmac_probe(struct pla val &= ~(1 << NSS_COMMON_CLK_SRC_CTRL_OFFSET(gmac->id)); switch (gmac->phy_mode) { case PHY_INTERFACE_MODE_RGMII: + case PHY_INTERFACE_MODE_RGMII_ID: + case PHY_INTERFACE_MODE_RGMII_RXID: + case PHY_INTERFACE_MODE_RGMII_TXID: val |= NSS_COMMON_CLK_SRC_CTRL_RGMII(gmac->id) << NSS_COMMON_CLK_SRC_CTRL_OFFSET(gmac->id); break; @@ -444,6 +453,9 @@ static int ipq806x_gmac_probe(struct pla val |= NSS_COMMON_CLK_GATE_PTP_EN(gmac->id); switch (gmac->phy_mode) { case PHY_INTERFACE_MODE_RGMII: + case PHY_INTERFACE_MODE_RGMII_ID: + case PHY_INTERFACE_MODE_RGMII_RXID: + case PHY_INTERFACE_MODE_RGMII_TXID: val |= NSS_COMMON_CLK_GATE_RGMII_RX_EN(gmac->id) | NSS_COMMON_CLK_GATE_RGMII_TX_EN(gmac->id); break;